Adapter eMMC/JTAG dla Riff Box 2 - RC3000

Adapter eMMC/JTAG dla Riff Box 2 - RC3000is an additional adapter for Riff BOX that allows you to solve problems with ISP communication. From now on it is not necessary to desolder the resistor on the CLK bus. Of course, it also allows operation of phones with damaged JTAG points (access to ROM2 via EMMC) or write / read EMMC (applicable for data recovery using the new IDC30 pin connector). Thanks to it you can do EMMC format or low-format in case of EMMC damage, repartitions (Slave / Master) or EMMC cloning. It also allows connection in ISP mode (directly into the phone's board without removing the EMMC chip) and Direct (by removing the BGA chip and soldering to the appropriate memory fields or using an adapter). We connect via JTAG and IDC20 socket.

Powered by MULTI-COM

•   JTAG: GND, TRST, TDI, TMS, TDO, TCK, RTCK, NRST, VCC
•   eMMC: DAT0, DAT1, DAT2, DAT3, CLK, CMD, GND, VCCQ, VCC 3.3V, RST
•   GPIO: 1, 2, 3, 4, 5, 6, 7, 8, 10, 11, 12, 13, 14, 15, 16, 17, 19, 20, 21, 22, 23, 24
•   SDW: DI0, CLK, D0, GND
•   CLK: works in Buffer (level driver shifter) or direct (without buffer) mode

Adapter and RIff BOX2 capabilities in ISP and Direct modes:

1.   Read / Write EMMC in ISP mode (directly in the system)
2. - Read / Write EMMC in Direct mode (EMMC installed in the adapter)
3. - reading information from EMMC (counter of readings / records, number of errors)
4. - pausa and resume in reading data from EMMC
5. - EMMC factory format (in case of EMMC content damage)
6. - low level EMMC formatting (in case of damage to EMMC content)
7. - the ability to unlock / lock protected partitions (e.g. User Area)
8. - intelligent EMM distribution

• blue color
• dimensions: 450 * 950 * 170
• weight: 100 gr