New products in section GSM products

JCID Face ID Non-Removal Repair FPC Flex Cable for iPhone 12 mini - This flex cable is intended for non-removal repair of Face ID on iPhone 12 mini. To be used with V1SE/V1S Pro programmer and JC V1S Face ID Read / Write Board.

Adapter module V1S REVOLUTION FACE ID X-14PM for JCID V1S/V1SE/V1S Pro - programmers is an innovative Face ID repair method that allows for repair without having to disassemble the entire module and perform precise soldering and then calibrating. Thanks to it, Face ID repair is very simple and comes down to a few clicks. Board compatible with JCID V1S / V1SE / V1S Pro programmers.

AV-Line Pro Lightning to Type-C intelligent detection charging cable iPhone/ iPad/ iPod (1.2M) Real time voltage and current monitoring, display charging protocol, compatible with apple PD protocol, Qualcomm QC2.0/3.0 protocol, Samsung PPS charging protocol, and HUAWEI's super fast charging protocol, data monitoring, fast charge, fast transmission.

AV-Line USB to Lightning intelligent detection charging cable iPhone/ iPad/ iPod (1M) Real time voltage and current monitoring, display charging protocol, compatible with apple PD protocol, Qualcomm QC2.0/3.0 protocol, Samsung PPS charging protocol, and HUAWEI's super fast charging protocol, data monitoring, fast charge, fast transmission.

2UUL Pre-Cut Thermal silicone pads 100pcs good heat conduction, very good malleability, widely used in mobile phones, small electronic products servicing. Dimension: 12x12x1.5mm

i2C Face-14 Face ID Dot-Matrix repair instrument for iPhone X-14Pro Max/iPad series a programmer designed to repair the face ID.

The soldering tip cleaner is an effective method of quickly cleaning soldering tips without heat loss. The entire cleaning process is done using low abrasion brass, minimizing thermal fluctuations compared to using a wet sponge and reducing the oxidation of the tip surface. It has a stainless steel housing, resistant to high temperatures.

Universal PullUp PU eMMC cable for VR-Table (VR64) allows you to amplify the CMD or DATA signal with the value of 115, 18, 25, 35, 50, 100 Ohm and 10, 50 kOhm for ISP readings. Connect the cable to the appropriate Power Socket (e.g. 1.8V, 2.8V or 3.3V) in the VR-Table and connect it to the signal you want to amplify, i.e. CMD or DATA, and then select the gain value with the switch. The cable is applicable to probes type VR64 (1mm/69mm)

USB cable (D+, D-, 5V, GND) with 4mm banana connectors (VR70/73M) is an additional cable for VR-Table that allows you to easily connect any device requiring USB transmission to a computer via VR-Table (D=, D-, 5V, GND). Thanks to the use of banana connectors, it is possible to combine signals, e.g. in order to additionally connect an oscilloscope / logic analyzer. To use with VR70/73M probes.

JC V1S Pro - programmer for repairing Apple phones/tablets is solution for iPhone servicing: Read / Write NAND data. Calibrate battery health data. Repair True Tone, Unbind WiFi. JC V1S Pro combines functions of Pro1000S, V1SE P7, P14, P13, Jbox programmers and can be used with their adapters.