Dirt/Dust water and alcohol removers

PCB PLUS cleaner is designed to clean any residues after soldering from the surfaces of printed circuit boards. It dissolves flux residues, including rosin. The liquid does not attack the substrate or structural elements of printed circuit boards. Special brush allows to precisely access to the cleaned surface, for this reason it may remove even the smallest particles and debris. Perfect for cleaning PCBs after repair and assembly.

Cleanser PCC 15 100ml is a professional solution for cleaning circuit boards, especially solder residues. The preparation does not react with materials used in electronics.

Cleanser PCC 15 500ml is a professional solution for cleaning circuit boards, especially solder residues. The preparation does not react with materials used in electronics.

Cleanser PCC15 150ml + brush is a professional solution for cleaning circuit boards, especially solder residues. The special brush allows precise access to the surface to be cleaned. The preparation does not react with materials used in electronics.

Electronic Water 500ml is an ultra-high resistance and very low conductivity (less than 0.1 uS) water. Ideal for washing PCB after washing in ultrasonic cleaners and the cleaning of electronics to all kinds of water-soluble zalaniach type: juices, coffee, tea. Dissolves and leaches substances that cause oxidation (corrosion), fully regenerates freshly flooded equipment. Recommended dilution water concentrates liquids ultrasonic cleaners.

Microsonic Clean PCB K2 500ml is professional, water, non-flammable liquid for quick cleaning of PCBs in ultrasonic cleaners. It removes all kinds of contamination after soldering, perfect for the removal of flooding not only liquid water-rozcieñczalnymi. Ideally it removes operational dust, oil, soot, pollution, organic and mineral.

PCB (Circuit boards) Cleanser 500ml is a cleaning fluid for circuit boards (PCB). Quickly and effectively removes residues polutownicze. It leaves no residue - quickly evaporated. Application: circuits W.N. and RF

PCB cleaner (water based) 1L it's special designed Printed Circuit Boards cleaner that allows to clean PCB after manual or automatic soldering. Can be used for cleaning bga rebailing kits.

PCB CLEANER KT-6 cleaning agent after soldering created for electronics professional cleaner for SIT and TEMPLATES and PCBs after soldering processes. The preparation has increased efficiency in ultrasonic cleaners, especially after heating to 30-60 ° C (on average 3 to 6 minutes is sufficient depending on the bath tub capacity and the degree of contamination), the fluid can be used as a replacement for "WD-40" preparations for maintenance locks, padlocks and unscrewing rusty screws, Recommended by service technicians for speed, safety and efficiency.