Cables and Adapters for fast reading using EMMC devices

Adapter eMMC/JTAG dla Riff Box 2 - RC3000 is an additional adapter for Riff BOX that allows you to solve problems with ISP communication. From now on it is not necessary to desolder the resistor on the CLK bus. Of course, it also allows operation of phones with damaged JTAG points (access to ROM2 via EMMC) or write / read EMMC (applicable for data recovery using the new IDC30 pin connector). Thanks to it you can do EMMC format or low-format in case of EMMC damage, repartitions (Slave / Master) or EMMC cloning. It also allows connection in ISP mode (directly into the phone's board without removing the EMMC chip) and Direct (by removing the BGA chip and soldering to the appropriate memory fields or using an adapter). We connect via JTAG and IDC20 socket.

Adapter for ATF 20PIN EMMC - RJ45 is used to allow connection EMMC Adapter with 20 pin connector to ATF Box.

EMMC adapter for Easy Z3x JTAG Box allows to easy repair of phones with disabled access to bootloader via DCC (GT-i9300/N7100/N719/N7102) or phones with demaged JTAG pinouts (access to ROM2 by EMMC). Adapter allows also in PRO version for low level formating of EMMC, easy one button repair boot via EMMC Direct, repartition Slave/Master. Our adapter you can use for ISP (in phone board) and direct connection.

eMMC/UFS ISP Adapter for Flash64 - 2026 Version an adapter featuring an additional module designed to improve ISP communication with eMMC chips.

FPC flex eMMC, UFS for F64 V2

Jumper wire/Copper spool wire 0.10mm/50m is a thin (0.10mm) insulated wire to make precise connections - are ideal for connecting corroded tracks in phones and other repair work. Thanks to its thick it also successfully used for soldering JTAG and when reading dump by EMMC

MiPi Tester eMMC / UFS ISP Adapter for MiPi Tester Big Box - Adapter allows you to service any device with ISP pinouts via UFS/eMMC interface. Intended for MiPi Tester Box. Thanks to the use of a special FPC tape with USB-C sockets data transfer is stable and the connection is trouble-free.

Moorc E-Mate X 13in1 - ICFriend Edition is the latest version of a set of adapters allowing for direct eMMC memory connection and read and/or write it contest. Adapter/Socket is fully compatible with many eMMC devices, such as Riff Box, Riff Box 2, Medusa Pro Box, Z3X Easy Jtag Box, Easy Z3x Plus, GPG EMMC Box, UFi Box, etc. The new version in comparison to the 2017 edition allows in addition to previously supported pinouts also reading the latest eMMCs BGA254, BGA100, BGA136, BGA168.

SD-EMMC Plus Adapter - Model SE-P1 is the latest adapter to connect eMMC memory using ISP or after Chip-Off by ordinary SD card reader or MMC Plus card reader (8-bit transmission). In addition, the adapter has a possibility to choose whether the power to eMMC (VCC and VCCq) is taken from the reader, ie. 3.3V or from an external power source Lab power supply (VccQ and Vcc)

Set 140 pcs. Of wires to the contact plate WJW-70B kit includes jumper connecting different length and color, to be joined on the fields included in our ofercie.płytkach contact. Content of 140 different colored jumper lengths of 2, 5, 7, 10, 12, 15, 17, 20, 22, 25, 50, 75, 100, 125mm. The whole is packaged in a box aesthetic.